The Unofficial JGMaker (& JGAurora) Wiki

This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong.

==== Getting prints to stick ====
Many of the Z-603S printers come with print beds that are not flat. This is a problem, as it makes it nearly impossible to get large prints to be stuck down evenly to the printing surface.

There are a few solutions for this:
  - Ask JGAurora for a non-warped bed (good luck...), or buy a new bed from their Amazon store [[https://www.amazon.com/dp/B078RLGMTS/?&_encoding=UTF8&tag=samuelpinches-20&linkCode=ur2&linkId=1dd28a9959680efdc3ef4f2d8c929be4&camp=1789&creative=9325|here]].
  - Put up with it, and use the flattest region on the bed you can find - giving up on any hope of printing large prints
  - Buy a new perfectly flat [[z-603s:cast-aluminium-print-bed|custom cast aluminium print bed]]
  - Install a [[z-603s:firmware|custom firmware]] on your printer, and go through the [[z-603s:mesh bed levelling routine]] to compensate for the uneven surface.
  - Modify your printer with an [[z-603s:bed-levelling-probe|automatic bed levelling probe]].

The Unofficial JGMaker (& JGAurora) Wiki

User Tools

Site Tools