a5:programmable-power-supply-control
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
| a5:programmable-power-supply-control [2018/07/05 21:37] – [Use New Functions] aeket | a5:programmable-power-supply-control [2020/12/25 02:13] (current) – external edit 127.0.0.1 | ||
|---|---|---|---|
| Line 4: | Line 4: | ||
| The changes shown here require knowledge in the field of Arduino, Marlin firmware and electrical engineering and can overwhelm normal users. Also, I would like to point out possible dangers that exist in certain interventions. All adjustments have been checked for function. | The changes shown here require knowledge in the field of Arduino, Marlin firmware and electrical engineering and can overwhelm normal users. Also, I would like to point out possible dangers that exist in certain interventions. All adjustments have been checked for function. | ||
| - | **Difficulty: | + | **Difficulty: |
| **What is this about?** \\ | **What is this about?** \\ | ||
| Line 63: | Line 63: | ||
| ==== Customize the Marlin firmware ==== | ==== Customize the Marlin firmware ==== | ||
| - | In the Arduino IDE open the **A5 Custom Community Firmware** (see article here in WIKI).\\ | + | In the Arduino IDE open the **A5 Custom Community Firmware** (see [[a5: |
| __ | __ | ||
| The following adjustments are made in the " | The following adjustments are made in the " | ||
| Line 145: | Line 145: | ||
| I had developed a complex special housing for the momentary switch and the solid state relay, in which the circuit should find its place. This would look like this: | I had developed a complex special housing for the momentary switch and the solid state relay, in which the circuit should find its place. This would look like this: | ||
| + | |||
| {{: | {{: | ||
| + | |||
| Electrically everything worked wonderfully. Unfortunately I noticed a problem after assembling the A5. The measurement of the available space above the momentary switch upper edge was wrong. The Y-gantry does not have enough room to move because the housing of the momentary switch was too high.\\ | Electrically everything worked wonderfully. Unfortunately I noticed a problem after assembling the A5. The measurement of the available space above the momentary switch upper edge was wrong. The Y-gantry does not have enough room to move because the housing of the momentary switch was too high.\\ | ||
| \\ | \\ | ||
| Line 181: | Line 183: | ||
| AETEK Firmware:\\ | AETEK Firmware:\\ | ||
| {{: | {{: | ||
| - | \\ | + | {{: |
| After the successful update of the MKS display firmware it should now look like this:\\ | After the successful update of the MKS display firmware it should now look like this:\\ | ||
| Line 218: | Line 220: | ||
| === Operation via software (GCODES) === | === Operation via software (GCODES) === | ||
| - | GCODES can be sent directly to the A5 via USB, e.g. Pronterface. \\ | + | GCODES can be sent directly to the A5 via USB, e.g. [[: |
| There is also the option to send stored GCODES from a storage device, such as USB stick or SD card. \\ | There is also the option to send stored GCODES from a storage device, such as USB stick or SD card. \\ | ||
| Which GCODES are of interest for this project?\\ | Which GCODES are of interest for this project?\\ | ||
a5/programmable-power-supply-control.1530790672.txt.gz · Last modified: 2020/12/25 02:13 (external edit)
